Loopback fails to load on kernel boot
FedoraForum.org - Fedora Support Forums and Community
Results 1 to 3 of 3
  1. #1
    RaXeT Guest

    Unhappy Loopback fails to load on kernel boot

    What needs to be done to repair a broken loopback process?

    I made a custom kernel as 2.6.13-1.1600_FC5 (done this since August).

    I rebooted, and now can’t get past this:

    “Bringing up loopback” message.

    I can rmmod loop and again modprobe loop, but lsmod doesn’t show loop?

    I’m able to do Interactive startup and skip the Network initialization and even

    roll the more new kernel 1601.

    I can term the session at any time and cleanly shutdown/reboot.

    Any ideas what I need to do to restore a this non functioning loopback process?

    Thanks in advance,

    RaXeT

  2. #2
    jsimmonds Guest
    Did you comment out the loopback devices when you complied the custom Kernel?

  3. #3
    RaXeT Guest
    Negative. All my kernels have loopback. The .config shows it enabled and set.

Similar Threads

  1. instal fails at kernel load
    By johnfw in forum Installation, Upgrades and Live Media
    Replies: 9
    Last Post: 25th February 2006, 10:04 PM
  2. Replies: 1
    Last Post: 2nd June 2005, 07:35 PM
  3. CUPS fails to load during boot.
    By LaVacaLoca in forum Using Fedora
    Replies: 4
    Last Post: 12th May 2005, 11:13 PM
  4. Network works at boot, then fails on load
    By fleece in forum Servers & Networking
    Replies: 1
    Last Post: 7th April 2005, 03:03 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •