Hi guys!

So I'm using Fedora 28 and since then I've been having problems with my wireless device because I have a Dell laptop. It turns out that I installed RPMFusion and all the drivers for my Broadcom BCM4312 device, but when I ask for the device to read, the right thing was to be configured to use the "wl" driver, but note that when I play the "lspci -v "it returns me that my device is using the" b43-pci-bridge "drive and for it to work it needs to be in" wl ". How can I proceed in relation to this? Thank you in advance for your attention. Below I will paste the command reading "lspci -v".

0c:00.0 Network controller: Broadcom Inc. and subsidiaries BCM4312 802.11b/g LP-PHY (rev 01)
Subsystem: Dell Wireless 1397 WLAN Mini-Card
Flags: bus master, fast devsel, latency 0, IRQ 17
Memory at f69fc000 (64-bit, non-prefetchable) [size=16K]
Capabilities: [40] Power Management version 3
Capabilities: [58] Vendor Specific Information: Len=78 <?>
Capabilities: [e8] MSI: Enable- Count=1/1 Maskable- 64bit+
Capabilities: [d0] Express Endpoint, MSI 00
Capabilities: [100] Advanced Error Reporting
Capabilities: [13c] Virtual Channel
Capabilities: [160] Device Serial Number 8e-46-fe-ff-ff-84-c4-17
Capabilities: [16c] Power Budgeting <?>
Kernel driver in use: b43-pci-bridge
Kernel modules: wl