PDA

View Full Version : Xorg vs. VGA 5 BNC cable



wslusarczy
10th January 2007, 07:44 PM
Hello,

Well, I have been trying to start Xserver with the 5 BNC cable connected, without results. I mean Xserver starts but only at resolution of 800x600 and 60 Hz. However, when I change cable to a regular D-sub everything is fine. I also had tried to start Xserver first with D-sub cable, and then changed it to 5 BNC - and of course it works (1152x864 / 90Hz), but this is not a solution...

Does somebody know how to force Xserver to start and work correctly with the 5 BNC?

Some data: 5 BNC cable taken from Sony GDM-FW900 Monitor set, similar to this one (http://www.kramerelectronics.com/cables/item.asp?desc=12).

Graphic Card: ATI Radeon Mobility 7500, Monitor: EIZO FlexScan T765 and Fedora 4

/etc/X11/xorg.conf (part)

Section "Monitor"
Identifier "Monitor0"
VendorName "Monitor Vendor"
ModelName "Eizo T765"
HorizSync 30.0 - 115.0
VertRefresh 50.0 - 160.0
Option "dpms"
# 1152x864 @ 90.00 Hz (GTF) hsync: 81.90 kHz; pclk: 128.42 MHz
Modeline "1152x864" 128.42 1152 1232 1360 1568 864 865 868 910 -HSync +Vsync
EndSection

Section "Device"
Identifier "Videocard0"
Driver "radeon"
VendorName "Videocard vendor"
BoardName "ATI Radeon Mobility 7500"
EndSection

Section "Screen"
Identifier "Screen0"
Device "Videocard0"
Monitor "Monitor0"
DefaultDepth 24
SubSection "Display"
Viewport 0 0
Depth 24
Modes "1152x864"
EndSubSection
EndSection

Thank you in advance and regards,
/WS