View Full Version : cannot select 1440 * 900 resolution

25th November 2006, 07:10 PM

I have a fresh fedora core 5 install on my new laptop (Dell Inspiron 640m) and while i can select the correct monitor type (with correct resolutuion) i can not select the correct screen resolution.

I have installed the resolution915 package but still cannot set (or even see it in the drop down list) the correct resolution.

Does anyone have any tips or ideas.

Thanks in advance,


27th November 2006, 03:32 PM
Check the driver being used. If it is the i810 you could try reading this thread:-

30th November 2006, 07:41 PM
At the moment it is using somekind of generic driver, i did not switch it to the Intel driver because my graphics card was not listed there. I will give it a try next time i boot into FC5