View Full Version : problems after update

20th November 2006, 02:15 PM
I have created a myth box. I had video working and was able to watch TV just fine. Then after i performed "yum update" the video and sound stopped working. I was able to get the audio working again - I can hear the TV show but I can not see anything.

I tried removing itvt-firmware then re-installing it but this did not make a difference. What else should I try to do?

hardware: PVR-500

Thanks in advance,

20th November 2006, 09:30 PM
Look and see if SELinux got enabled by the updates - I've had this happen before and it prevented xine and mplayer from working properly. As soon as I turned it off, the players worked correctly.

20th November 2006, 10:58 PM
Thanks for the response.

I have checked the security levels and it appears that SELinux is still disabled. Any other ideas?

I find it also strange that when i'm listening to TV (since thats all that works) the sound is now choppy. when checking the mythfrontend output, i see that there are a lot of "prebuffering pause" messages. I don't recall these being there before.