PDA

View Full Version : Crash again



lewjoubert
8th November 2006, 10:48 PM
I recently had a problem where my laptop went to sleep (FC5) and would'nt wake up resulting in me turning the power off and rebooting. Thereafter I could not get the graphics mode, only a 'DOS' type login screen. After much frigging around and unable to find help to retore FC5 I re-installed FC5 loosing all data etc. Most irritating.

Now sme 3 weeks later low and behold a similar occurance. While installing software and waiting for pckage updates to finish, the laptop went into sleep mode (it was taking so long I almost joined it!) - moving the mouse, tapping keys etc. could not bring the machine back, so after trying everything I could and holding my breath I turned off the power.

Booted up and low and behold, the same problem as before - unable to access the graphics login screen and rest of the apps.

Login in in 'DOS' mode and doing ls I can see all the directories and can change into them.

However if I do 'cd Desktop' I get the following messages:
hdc: DMA interrupt recovery
hdc: lost interrupt
hdc: status error: status=0x58 {DriveReady SeekComplete DataRequest}
hdc: failed op code was:unknown
hdc: drive not ready for command
hdc: status timeout: status=0xd0 {Busy}
hdc: failed opcode was :unknown
hdc: drive not ready for command
hdc: ATAPI reset complete
_
... and the machine hangs there.

Tapping ENTER key restore prompt [mc@localhost Desktop]$

Any ideas before I drop FC once and for all?

VictorienSardou
14th November 2006, 04:32 PM
do you know what make and model your hard disk is?
have you downloaded from the manufacturer the utility for checking the hard drive?

what is the output of:
# /sbin/hdparm /dev/hda
# /sbin/hdparm -i /dev/hda