USB hp4200C scanner on fedora core 3

[MArco_it]

Hi !
I need help for configure the scanner
I found 2 rpm of sane patched for my scanner and I installed it whit
[root@localhost marco]# rpm -i --force sane-backends-1.0.12-4.i686.rpm



[root@localhost marco]# sane-find-scanner

# No SCSI scanners found. If you expected something different, make sure that
# you have loaded a SCSI driver for your SCSI adapter.
# Also you need support for SCSI Generic (sg) in your operating system.
# If using Linux, try "modprobe sg".

found USB scanner (vendor=0x03f0, product=0x0105) at libusb:002:002
# Your USB scanner was (probably) detected. It may or may not be supported by
# SANE. Try scanimage -L and read the backend's manpage.

# Scanners connected to the parallel port or other proprietary ports can't be
# detected by this program.


[root@localhost marco]# scanimage hp4200:libusb:002:002
scanimage: no SANE devices found



This is my first time whit sane and I very need to run my scanner..
Thanks for help

MArco

[SuperNu]

Try xsane or kooka and see if you can scan an image that way. If that doesn't work, then try adding usb 0x03f0 0x0105 to /etc/sane.d/hp.conf, power off then power on your scanner and try xsane or kooka again.

--SN