Keyspan ER-V2 RF Remote

[jccheng]

Does anyone have any experience getting the Keyspan ER-V2 RF remote to work in Fedora 11? The USB RF reciever does seem to be recognized. Here is the output from 'lsusb -v':

Bus 006 Device 002: ID 1784:0008 TopSeed Technology Corp.
Device Descriptor:
bLength 18
bDescriptorType 1
bcdUSB 2.00
bDeviceClass 0 (Defined at Interface level)
bDeviceSubClass 0
bDeviceProtocol 0
bMaxPacketSize0 8
idVendor 0x1784 TopSeed Technology Corp.
idProduct 0x0008
bcdDevice 1.01
iManufacturer 1 Topseed Technology Corp.
iProduct 2 eHome Infrared Transceiver
iSerial 3 TS0004GF
bNumConfigurations 1
Configuration Descriptor:
bLength 9
bDescriptorType 2
wTotalLength 32
bNumInterfaces 1
bConfigurationValue 1
iConfiguration 0
bmAttributes 0xa0
(Bus Powered)
Remote Wakeup
MaxPower 100mA
Interface Descriptor:
bLength 9
bDescriptorType 4
bInterfaceNumber 0
bAlternateSetting 0
bNumEndpoints 2
bInterfaceClass 255 Vendor Specific Class
bInterfaceSubClass 255 Vendor Specific Subclass
bInterfaceProtocol 255 Vendor Specific Protocol
iInterface 0
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x01 EP 1 OUT
bmAttributes 3
Transfer Type Interrupt
Synch Type None
Usage Type Data
wMaxPacketSize 0x0020 1x 32 bytes
bInterval 0
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x82 EP 2 IN
bmAttributes 3
Transfer Type Interrupt
Synch Type None
Usage Type Data
wMaxPacketSize 0x0020 1x 32 bytes
bInterval 0
Device Status: 0x0000
(Bus Powered)

I am on Fedora 11, kernel 2.6.29.6-213.fc11.i686.PAE. Any help or suggestions would be greatly appreciated.

[jccheng]

Figured it out. Needed to add "include </usr/share/lirc-remotes/mceusb/lircd.conf.mceusb>" to /etc/lircd.conf.