Hi
I have three LAN cards
1. Marvell Technology Group Ltd. 88E8056 PCI-E Gigabit Ethernet Controller : one, on board (eth0)
2. Realtek Semiconductor Co., Ltd. RTL-8169 Gigabit Ethernet : 2 ea, PCI card (eth1, eth2)
after some modification in the network configuration utility, eth1 does not appear ...
Maybe eth1 is deleted ...
Would you tell me how to recover eth1 ?
---------------------------------------------
/etc/sysconfig>dmesg | grep eth
Driver 'sd' needs updating - please use bus_type methods
Driver 'sr' needs updating - please use bus_type methods
eth0: RTL8110s at 0xffffc2000104ec00, 00:1b:2f:2b:bc:dc, XID 04000000 IRQ 18
udev: renamed network interface eth0 to eth2
sky2 eth0: addr 00:1d:60:e9:7d:7b
sky2 eth0: enabling interface
ADDRCONF(NETDEV_UP): eth0: link is not ready
sky2 eth0: Link is up at 100 Mbps, full duplex, flow control both
ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
r8169: eth2: link up
r8169: eth2: link up
eth0: no IPv6 routers present
eth2: no IPv6 routers present
--------------------------------------------
Linear Mode
