I have FC8 x64 with an nVidia Geforce 6100 nForce 405 (rev a2) and a 24" Westinghouse L2410NM monitor. When I set the res to 1920x1200 the X desktop is too large for the screen, although monitor is capable of 1920x1200.
I've tried modifying the xorg.conf but I'm new to X so I'm not sure of what I'm doing. If anyone can help, it would be much appreciated.
Section "Monitor"
Identifier "Monitor0"
VendorName "WDE"
ModelName "L2410NM"
HorizSync 30.0 - 80.0
VertRefresh 56.0 - 75.0
Option "DPMS"
EndSection
Section "Device"
Identifier "Videocard0"
Driver "nv"
EndSection
Section "Screen"
SubSection "Display"
Viewport 0 0
Depth 24
EndSubSection
Identifier "Screen0"
Device "Videocard0"
Monitor "Monitor0"
DefaultDepth 16
EndSection
Settings from manufacturer:
Timing characteristics
VESA GTF support............ Not supported
Horizontal scan range....... 30-80kHz
Vertical scan range......... 56-75Hz
Video bandwidth............. 160MHz
Extension blocks............ n/a
Timing recommendation #1.... 1920x1200 at 60Hz
Modeline................ "1920x1200" 154.000 1920 1968 2000 2080 1200 1203 1209 1235 +hsync -vsync
Timing recommendation #2.... 1920x1080 at 60Hz
Modeline................ "1920x1080" 148.500 1920 2008 2052 2200 1080 1084 1089 1125 +hsync +vsync
Linear Mode
