Hello
I am new to Fedora, thought I would give FC8 a spin. So far I have managed to set it up pretty well how I want but for some reason I can't get my PCI DVB card to work. I'm sure its supposed to be supported by the kernel since 2.6.18.XX.
The card is detected and I have the TV option when I open Kaffeine but when I go into channels and try to scan I hit a wall. It starts of o.k and the SVN and signal bars start filling up and the green lock light comes on but the progress bar shows 0% scanned and after about 5 seconds it just stops the scan.
Anybody got any ideas how to get it to scan?
Many thanks
Heres my dmesg (from DVB part down):
Code:
ACPI: PCI Interrupt 0000:00:0a.0[A] -> GSI 18 (level, low) -> IRQ 23
saa7133[0]: found at 0000:00:0a.0, rev: 208, irq: 23, latency: 32, mmio: 0xec004000
saa7133[0]: subsystem: 1043:4857, board: ASUSTeK P7131 Dual [card=78,autodetected]
saa7133[0]: board init: gpio is 0
input: saa7134 IR (ASUSTeK P7131 Dual) as /class/input/input7
saa7133[0]: i2c eeprom 00: 43 10 57 48 54 20 1c 00 43 43 a9 1c 55 d2 b2 92
saa7133[0]: i2c eeprom 10: 00 01 20 00 ff 20 ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 20: 01 40 01 02 03 01 01 03 08 ff 00 cb ff ff ff ff
saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 40: ff 21 00 c2 96 10 03 32 15 00 ff ff ff ff ff ff
saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
tuner 0-004b: chip found @ 0x96 (saa7133[0])
tuner 0-004b: setting tuner address to 61
tuner 0-004b: type set to tda8290+75a
tuner 0-004b: setting tuner address to 61
tuner 0-004b: type set to tda8290+75a
saa7133[0]: registered device video0 [v4l2]
saa7133[0]: registered device vbi0
saa7133[0]: registered device radio0
ACPI: PCI Interrupt 0000:01:00.0[A] -> GSI 16 (level, low) -> IRQ 20
NVRM: loading NVIDIA UNIX x86 Kernel Module 100.14.19 Wed Sep 12 14:12:24 PDT 2007
DVB: registering new adapter (saa7133[0])
DVB: registering frontend 0 (Philips TDA10046H DVB-T)...
tda1004x: setting up plls for 48MHz sampling clock
SELinux: initialized (dev ramfs, type ramfs), uses genfs_contexts
tda1004x: found firmware revision 26 -- ok
NET: Registered protocol family 10
lo: Disabled Privacy Extensions
agpgart: Found an AGP 3.5 compliant device at 0000:00:00.0.
agpgart: Putting AGP V3 device at 0000:00:00.0 into 8x mode
agpgart: Putting AGP V3 device at 0000:01:00.0 into 8x mode
device-mapper: multipath: version 1.0.5 loaded
loop: module loaded
EXT3 FS on dm-0, internal journal
kjournald starting. Commit interval 5 seconds
EXT3 FS on sda1, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
SELinux: initialized (dev sda1, type ext3), uses xattr
SELinux: initialized (dev tmpfs, type tmpfs), uses transition SIDs
Adding 2031608k swap on /dev/mapper/VolGroup00-LogVol01. Priority:-1 extents:1 across:2031608k
SELinux: initialized (dev binfmt_misc, type binfmt_misc), uses genfs_contexts
IA-32 Microcode Update Driver: v1.14a <tigran@aivazian.fsnet.co.uk>
ip6_tables: (C) 2000-2006 Netfilter Core Team
Netfilter messages via NETLINK v0.30.
nf_conntrack version 0.5.0 (16384 buckets, 65536 max)
ip_tables: (C) 2000-2006 Netfilter Core Team
audit(1195062785.580:4): audit_pid=1773 old=0 by auid=4294967295 subj=system_u:system_r:auditd_t:s0
SELinux: initialized (dev rpc_pipefs, type rpc_pipefs), uses genfs_contexts
Bluetooth: Core ver 2.11
NET: Registered protocol family 31
Bluetooth: HCI device and connection manager initialized
Bluetooth: HCI socket layer initialized
Bluetooth: L2CAP ver 2.8
Bluetooth: L2CAP socket layer initialized
Bluetooth: RFCOMM socket layer initialized
Bluetooth: RFCOMM TTY layer initialized
Bluetooth: RFCOMM ver 1.8
eth1: Media Link Off
ADDRCONF(NETDEV_UP): eth1: link is not ready
agpgart: Found an AGP 3.5 compliant device at 0000:00:00.0.
agpgart: Putting AGP V3 device at 0000:00:00.0 into 8x mode
agpgart: Putting AGP V3 device at 0000:01:00.0 into 8x mode
SELinux: initialized (dev sdb1, type vfat), uses genfs_contexts
UDF-fs: Partition marked readonly; forcing readonly mount
UDF-fs INFO UDF 0.9.8.1 (2004/29/09) Mounting volume 'DVD-VIDEO', timestamp 2007/11/14 01:47 (1000)
SELinux: initialized (dev sr0, type udf), uses genfs_contexts
SELinux: initialized (dev sdf1, type vfat), uses genfs_contexts
eth0: no IPv6 routers present
sr 1:0:0:0: [sr0] Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE,SUGGEST_OK
sr 1:0:0:0: [sr0] Sense Key : Hardware Error [current]
sr 1:0:0:0: [sr0] Add. Sense: Timeout on logical unit
end_request: I/O error, dev sr0, sector 1088
Buffer I/O error on device sr0, logical block 272
Linear Mode
