Two questions on using MA101 with FC1

RallyMonkey · #1 24th April 2004, 05:03 PM

I am trying to use the Netgear MA101 rev.b with my install of Fedora Core 1, but am having some problems. When I tried to use the Atmel one from sourceforge, on the installation I got a list of errors. Then I tried a different one that I forgot the name ( will try to remember) it looked like it installed o.k. But on the instructions for both it needs the card to be configured as an eth* correct? Because when I do it, the card is set up as wlan0. How could I get it to were it is eth*?

Second question. How could I delete the driver so I could start again on trying to install it?

Thanks!

Bana · #2 25th April 2004, 05:33 AM

If you installed it with rpm (pray tell you did?) then it should be a matter of rpm -e driver_name (to find out what it is called you might do a rpm -qa | grep netgear or try a few search words in place of netgear. HTH

RallyMonkey · #3 25th April 2004, 07:15 AM

Is there an RPM for it?