arescom NetDSL1000 and FC1

[Juan4Ever]

i just cant make it work...

any help?

i have a davicom ethernet card (cnet pro200) but i cant make it work too, FC1 only detect a generic ethernet card 10/100mb (eth0), if i install a davicom card it stay inactive.

iwas using mandrake 9.2 until the last week and all work fine there, no problems at all...

sorry if i make no sense in my post, is just i was all night awake trying to make it work and now it is 10 am:o and my english is not good really.

please help!

thanks.

[Jman]

I was going to recommend using the Davicom driver in Main Menu > Sustem Settings > Network but apparently you already tried that.

What's the problem with the generic driver, does it not have certain functionality? Does it even work?

Any details about the Mandrake configuration? I'm not familiar with the distro, but it may help. Any eth0 lines in /etc/modules.conf that worked would be helpful.

[Juan4Ever]

i get this when i run ifconfig

eth0 Link encap:Ethernet HWaddr 00:80:AD:70:9F:85
inet addr:192.168.1.2 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:84 errors:0 dropped:0 overruns:0 frame:0
TX packets:132 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:7987 (7.7 Kb) TX bytes:7349 (7.1 Kb)
Interrupt:5 Base address:0xa800

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:1492 errors:0 dropped:0 overruns:0 frame:0
TX packets:1492 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:1108154 (1.0 Mb) TX bytes:1108154 (1.0 Mb)

ppp0 Link encap:Point-to-Point Protocol
inet addr:200.28.25.195 P-t-P:10.52.40.3 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1492 Metric:1
RX packets:39 errors:0 dropped:0 overruns:0 frame:0
TX packets:45 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:4056 (3.9 Kb) TX bytes:2064 (2.0 Kb)

and this when i run "service network restart"

Interrupcion de la interfaz ppp0: uso: ifdown <nombre del dispositivo>
[FALLÃ]
Interrupcion de la interfaz eth0: [OK]
Interrupcion de la interfaz de loopback:[OK]
Configurando parámetros de red:[OK]
Activacion de la interfaz de loopback:[OK]
Activando interfaz eth0:[OK]
Activando interfaz ppp0: ./ifup: configuracion de ppp0 no encontrada.
Uso: ifup <nombre del dispositivo>
[FALLÃ]

my system is in spanish, i hope you could understand.