Fedora Linux Support Community & Resources Center
  #1  
Old 5th September 2006, 11:30 PM
ggeo Offline
Registered User
 
Join Date: Aug 2006
Location: Greece
Posts: 142
netgear wg311v3

Hello to everybody
I am new Linux user,so i need some help to move on.
The problem i have is with my wireless card(netgeag wg311v3)
I installed ndiswrapper(1.23edition,with kernel,kernel devel 2.6.17-1.2174_FC5)
Everything went ok.The drivers installed.
I execute ifconfig wlan0 and it shows:
wlan0 Link encap:Ethernet HWaddr 00:14:6C:76:86:1A
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:201 Memory:e6010000-e6020000

Then iwlist wlan0 scan and shows:
Warning: Driver for device wlan0 has been compiled with version 20
of Wireless Extension, while this program supports up to version 19.
Some things may be broken...

wlan0 Scan completed :
Cell 01 - Address: 00:14:BFB:10:BC
ESSID:"linksys"
Protocol:IEEE 802.11g
Mode:Managed
Frequency:2.462 GHz (Channel 11)
Quality:0/100 Signal level:-59 dBm Noise level:-256 dBm
Encryption key:off
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 22 Mb/s
6 Mb/s; 9 Mb/s; 12 Mb/s; 18 Mb/s; 24 Mb/s
36 Mb/s; 48 Mb/s; 54 Mb/s
Extra:bcn_int=100
Extra:atim=0

The problem is that when i go to the control panel,networks to create a new setting and i choose wireless connection it does not appear anywhere the wlan0 or netgeag or something!I have tried to do ifconfig eth0 down and ifconfig wlan0 up but still nothiong.I use a static address.
This is my problem.If anyone can help,I'd appreciate

When i do dmesg it shows:
.....
ndiswrapper version 1.23 loaded (preempt=no,smp=no)
ndiswrapper: driver wg311v3 (NETGEAR,02/22/2005,3.1.1.7) loaded
ACPI: PCI Interrupt 0000:01:08.0[A] -> Link [APC1] -> GSI 16 (level, high) -> IRQ 201
ndiswrapper: using irq 201
wlan0: vendor: ''
wlan0: ethernet device 00:14:6c:76:86:1a using NDIS driver wg311v3, 11AB:1FAA.5.conf
wlan0: encryption modes supported: WEP; TKIP with WPA, WPA2, WPA2PSK; AES/CCMP with WPA, WPA2, WPA2PSK
ADDRCONF(NETDEV_UP): wlan0: link is not ready
....
Also it shows :
...
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT]
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.HUB0._PRT]
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.AGPB._PRT]
ACPI: PCI Interrupt Link [LNK1] (IRQs 3 4 5 6 7 9 10 *11 12 14 15)
ACPI: PCI Interrupt Link [LNK2] (IRQs 3 4 5 6 7 9 10 11 12 14 15) *0, disabled.
ACPI: PCI Interrupt Link [LNK3] (IRQs 3 4 5 6 7 9 10 11 12 14 15) *0, disabled.
ACPI: PCI Interrupt Link [LNK4] (IRQs 3 4 *5 6 7 9 10 11 12 14 15)
ACPI: PCI Interrupt Link [LNK5] (IRQs 3 4 5 6 7 9 10 11 12 14 15) *0, disabled.
ACPI: PCI Interrupt Link [LUBA] (IRQs 3 4 5 6 7 *9 10 11 12 14 15)
ACPI: PCI Interrupt Link [LUBB] (IRQs 3 4 *5 6 7 9 10 11 12 14 15)
ACPI: PCI Interrupt Link [LMAC] (IRQs 3 4 5 6 7 9 10 11 12 14 15) *0, disabled.
ACPI: PCI Interrupt Link [LAPU] (IRQs 3 4 5 6 7 9 10 11 12 14 15) *0, disabled.
ACPI: PCI Interrupt Link [LACI] (IRQs 3 4 5 6 7 *9 10 11 12 14 15)
ACPI: PCI Interrupt Link [LMCI] (IRQs 3 4 5 6 7 9 10 11 12 14 15) *0, disabled.
ACPI: PCI Interrupt Link [LSMB] (IRQs 3 4 5 6 7 9 10 *11 12 14 15)
ACPI: PCI Interrupt Link [LUB2] (IRQs 3 4 5 6 7 9 10 *11 12 14 15)
ACPI: PCI Interrupt Link [LFIR] (IRQs 3 4 5 6 7 9 10 11 12 14 15) *0, disabled.
ACPI: PCI Interrupt Link [L3CM] (IRQs 3 4 5 6 7 9 10 11 12 14 15) *0, disabled.
ACPI: PCI Interrupt Link [LIDE] (IRQs 3 4 5 6 7 9 10 11 12 14 15) *0, disabled.
ACPI: PCI Interrupt Link [APC1] (IRQs *16), disabled.
ACPI: PCI Interrupt Link [APC2] (IRQs *17), disabled.
ACPI: PCI Interrupt Link [APC3] (IRQs *18), disabled.
ACPI: PCI Interrupt Link [APC4] (IRQs *19), disabled.
ACPI: PCI Interrupt Link [APC5] (IRQs *16), disabled.
ACPI: PCI Interrupt Link [APCF] (IRQs 20 21 22) *0, disabled.
ACPI: PCI Interrupt Link [APCG] (IRQs 20 21 22) *0, disabled.
ACPI: PCI Interrupt Link [APCH] (IRQs 20 21 22) *0, disabled.
ACPI: PCI Interrupt Link [APCI] (IRQs 20 21 22) *0, disabled.
ACPI: PCI Interrupt Link [APCJ] (IRQs 20 21 22) *0, disabled.
ACPI: PCI Interrupt Link [APCK] (IRQs 20 21 22) *0, disabled.
ACPI: PCI Interrupt Link [APCS] (IRQs *23), disabled.
ACPI: PCI Interrupt Link [APCL] (IRQs 20 21 22) *0, disabled.
ACPI: PCI Interrupt Link [APCM] (IRQs 20 21 22) *0, disabled.
ACPI: PCI Interrupt Link [AP3C] (IRQs 20 21 22) *0, disabled.
ACPI: PCI Interrupt Link [APCZ] (IRQs 20 21 22) *0, disabled.
...
Thanks![/COLOR]
Reply With Quote
Reply

Tags
netgear

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Netgear WG311v3 FC11 - card not being detected BlownCPU Servers & Networking 4 29th May 2011 08:30 AM
Wireless card problems. Netgear WG311v3. contempt Hardware & Laptops 4 25th November 2009 05:09 AM
netgear wg311v3 install dpx Servers & Networking 4 26th June 2007 07:23 AM
Netgear WG311v3 - ndiswrapper zealot Servers & Networking 3 5th February 2007 04:24 AM
Netgear WG311v3 mallex Hardware & Laptops 2 13th August 2006 04:21 AM


Current GMT-time: 19:14 (Saturday, 26-07-2014)

TopSubscribe to XML RSS for all Threads in all ForumsFedoraForumDotOrg Archive
logo

All trademarks, and forum posts in this site are property of their respective owner(s).
FedoraForum.org is privately owned and is not directly sponsored by the Fedora Project or Red Hat, Inc.

Privacy Policy | Term of Use | Posting Guidelines | Archive | Contact Us | Founding Members

Powered by vBulletin® Copyright ©2000 - 2012, vBulletin Solutions, Inc.

FedoraForum is Powered by RedHat