Hi All,
I'm hoping someone else has an Intel on-board video Chipset 845G that's working in Fedora Core 5. Any suggestions or ideas are very much appreciated!
Here are some targeted notes about what's going on:
/var/log/Xorg.0.log:
...
(II) LoadModule: "i810"
(II) Loading /usr/lib/xorg/modules/drivers/i810_drv.so
(II) Module i810: vendor="X.Org Foundation"
compiled for 7.0.0, module version = 1.4.1
Module class: X.Org Video Driver
ABI class: X.Org Video Driver, version 0.8
...
(II) I810: Driver for Intel Integrated Graphics Chipsets: i810, i810-dc100,
i810e, i815, i830M, 845G, 852GM/855GM, 865G, 915G, E7221 (i915),
915GM, 945G
(II) Primary Device is: PCI 00:02:0
(--) Assigning device section with no busID to primary device
(--) Chipset 845G found
...
(II) I810(0): VESA BIOS detected
(II) I810(0): VESA VBE Version 3.0
(II) I810(0): VESA VBE Total Mem: 832 kB
(II) I810(0): VESA VBE OEM: Intel(r)845G/845GL/845GE/845GV Graphics Chip Accelerated VGA BIOS
(II) I810(0): VESA VBE OEM Software Rev: 1.0
(II) I810(0): VESA VBE OEM Vendor: Intel Corporation
(II) I810(0): VESA VBE OEM Product: Intel(r)845G/845GL/845GE/845GV Graphics Controller
(II) I810(0): VESA VBE OEM Product Rev: Hardware Version 0.0
(II) I810(0): BIOS now sees 832 kB VideoRAM
...
(II) I810(0): Monitor0: Using hsync range of 31.50-37.90 kHz
(II) I810(0): Monitor0: Using vrefresh range of 50.00-70.00 Hz
(II) I810(0): Not using mode "800x600" (no mode of this name)
(II) I810(0): Increasing the scanline pitch to allow tiling mode (640 -> 1024).
(--) I810(0): Virtual size is 640x480 (pitch 1024)
(**) I810(0): *Built-in mode "640x480"
(II) I810(0): Attempting to use 60.00Hz refresh for mode "640x480" (841)
(==) I810(0): DPI set to (75, 75)
...
Change /etc/X11/xorg.conf to
HorizSync 30-70
VertRefresh 50-160
#HorizSync 31.5 - 37.9
#VertRefresh 50.0 - 70.0
No help!
Added
Virtual 1024 780
after
Viewport 0 0
But when I mouse around the viewport, after a few seconds I get flicker, roll.
Then black screen. Ctrl-alt-bksp no help. console init 3, init 5 no help. Reboot!