I'm trying to get my old Connectix B&W QuickCam parallel port camera to work. I installed all of the SANE rpms and edited /etc/sane.d/qcam.conf to enable the appropriate address:
0x378 # /dev/lp1
When I run xcam (as root) it indicates that there is a Connextix B&W QuickCam video camera attached, and it gives the adjustment controls for Brightness, Contrast, etc. If the camera is not plugged in, xcam just displays a generic screen without these controls. So I know it recognizes the camera and supports it. If I don't run as root it doesn't recognize the camera.
However when I click the "Play" button, the program immediately seg faults. (It displays Segmentation fault on the console, and the X screen stops responding. If I kill the xcam process the X screen goes away).
I get a similar seg fault when trying to use scanimage.
I have just run up2date, so I have the latest kernel and other updates. The problem did not change before or after the up2date.
The motherboard is an Asus CUV4X and I have tried setting the parallel to all of the parallel modes: Normal, EPP, ECP (DMA3), ECP+EPP. The result is the same in each case.
I also tried in qcam.conf: u0x378, with no change in result.
Is there something else I need to do to configure SANE, etc?
Linear Mode
