I am stuck with one problem after having installed a new Linux kernel .
I am able to reach the point where i enter the username and password . After which i dont see the desktop icons and stuff like that . I have given the step[ by step procedure i followed to create the new kernel.
I copied the tarball to /usr/src. Then i use these commands in the same order. I run the commands as a root user.
# make menuconfig
# make dep
# make clean
# make bzImage
# cp/usr/src/linux/22.214.171.124/arch/i386/boot/bzImage /boot/vmlinuz-2.4.35
# make modules
# make modules_install
Now i configure grub by adding the following lines
title Red Hat Linux(2.4.35)
kernel /boot/vmlinuz-2.4.35 ro root=/dev/hda2
Here i come to the end of the procedure.
I have not touched upon mkinitrd. Is it necessary??? Then how should i do it?
This was what was already in the grub.conf
default = 0
timeout = 10
splash image = (hd0,0) /grub/splashxpm.gz
kernel /vmlinuz-2.4.22-1.2115.nptl ro root=LABEL=/ rhgb
now my partition details are like this(what - where - filesystem)
/boot /dev/hda1 ext2
root /dev/hda2 ext2
swap /dev/hdc1 swap
So what should i do next??