Need help with partitions

[Hondo]

I installed FC3 following Jarreds instructions. Guess I left out a step when using Disk Druid to set up my partitions.

I was trying to use LVM and xfs to allow a partion called /video to grow when I needed to add a new drive.

I created a LVM parttition called /video. I then layed a xfs fill system over the /video partiition and told it to use all available space. It showed a partition called /sds6 with a size of about 70gigs leaving 70 gigs of free space available. I then created a partition called /sda7 formatted xfs.

I then continued the install.

I guess I left out a step because the /sda7 partion is not seen and is not 'seen''.

How can i resollve this without reinstalling ?

Your help would be appreciated.

[james_in_denver]

can you please post the results of "fdisk -l /dev/hda" (assuming that we are talking about the "primary master" ide disk, use "/dev/hdb" if it's on the "primary slave" disk.

And if you can post your "/etc/fstab" file as well.

[Hondo]

This is the fstab file;

# This file is edited by fstab-sync - see 'man fstab-sync' for details
LABEL=/1 / ext3 defaults 1 1
LABEL=/boot /boot ext3 defaults 1 2
none /dev/pts devpts gid=5,mode=620 0 0
none /dev/shm tmpfs defaults 0 0
none /proc proc defaults 0 0
none /sys sysfs defaults 0 0
LABEL=/video1 /video xfs defaults 1 2
LABEL=SWAP-sda5 swap swap defaults 0 0
/dev/hda /media/cdrecorder auto pamconsole,exec,noauto,managed 0 0
/dev/fd0 /media/floppy auto pamconsole,exec,noauto,managed 0 0