*I have just upgraded from core 2, to 3*
I have an 80GB Maxtor as a primary and I want to connect an 120GB Maxtor as a slave. This 120GB has my data on already. So, like I used to in Fc2, I connected it, fsck would tell me about a new hdd, I'd hop along into nano with /etc/fstab in my hands. Change it, reboot, and there it was. Fc3 is obviously different. When I boot up I get firstly an error when it's doing something about local disks (can't remember the exact phrase), then I get exited out of X, loads of errors because the master
drive is read-only, and then I freeze.
Should I change the fstab before I connect the hdd?