Broadcom Corporation BCM4318 [AirForce One 54g] 802.11g

Rykkan · #1 21st June 2008, 05:14 PM

Hi Everyone.
I just installed Fedora Project 8 on my Gateway Laptop and am Dual-Booting XP. I installed it from the 64 Bit LiveDVD Torrent. I am doing Live Updates on it right now, because my Wired Connection works. But my Wireless Doesn't. I have used ndiswrapper for the drivers, but it doesn't show up in the Network Device Control Service. Also, how do I make my touchpad not tap to click. its annoying.

[root@localhost ~]# lspci
00:00.0 Host bridge: ATI Technologies Inc Radeon Xpress 200 (RS480/RS482/RX480/RX482) Chipset - Host bridge (rev 01)
00:02.0 PCI bridge: ATI Technologies Inc RS480 PCI-X Root Port
00:06.0 PCI bridge: ATI Technologies Inc RS480 PCI Bridge
00:13.0 USB Controller: ATI Technologies Inc IXP SB400 USB Host Controller
00:13.1 USB Controller: ATI Technologies Inc IXP SB400 USB Host Controller
00:13.2 USB Controller: ATI Technologies Inc IXP SB400 USB2 Host Controller
00:14.0 SMBus: ATI Technologies Inc IXP SB400 SMBus Controller (rev 11)
00:14.1 IDE interface: ATI Technologies Inc Standard Dual Channel PCI IDE Controller
00:14.3 ISA bridge: ATI Technologies Inc IXP SB400 PCI-ISA Bridge
00:14.4 PCI bridge: ATI Technologies Inc IXP SB400 PCI-PCI Bridge
00:14.5 Multimedia audio controller: ATI Technologies Inc IXP SB400 AC'97 Audio Controller (rev 02)
00:14.6 Modem: ATI Technologies Inc SB400 AC'97 Modem Controller (rev 02)
00:18.0 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] HyperTransport Technology Configuration
00:18.1 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] Address Map
00:18.2 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] DRAM Controller
00:18.3 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] Miscellaneous Control
01:00.0 VGA compatible controller: ATI Technologies Inc M24 1P [Radeon Mobility X600]
02:00.0 Ethernet controller: Marvell Technology Group Ltd. 88E8036 PCI-E Fast Ethernet Controller (rev 10)
03:05.0 CardBus bridge: ENE Technology Inc CB1410 Cardbus Controller (rev 01)
03:07.0 Network controller: Broadcom Corporation BCM4318 [AirForce One 54g] 802.11g Wireless LAN Controller (rev 02)
03:0e.0 FireWire (IEEE 1394): VIA Technologies, Inc. IEEE 1394 Host Controller (rev 80)

[root@localhost ~]# iwconfig
lo no wireless extensions.

eth0 no wireless extensions.

[root@localhost ~]# ifconfig
eth0 Link encap:Ethernet HWaddr 00:03:25:33:2F

A
inet addr:192.168.1.102 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::203:25ff:fe33:2fda/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:183042 errors:0 dropped:0 overruns:0 frame:0
TX packets:133659 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:263939778 (251.7 MiB) TX bytes:9378442 (8.9 MiB)
Interrupt:18

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:5635 errors:0 dropped:0 overruns:0 frame:0
TX packets:5635 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:3219776 (3.0 MiB) TX bytes:3219776 (3.0 MiB)

Any Help would be appreciated. My Computer also uses the FN+F2 to turn it on and off.
Thank you for any help you can give me.