Hi,
On my system are 3 very old sidewinder gamepads daisychained plugged into my gameport, now under FC4 I got them to work by running these commands:
/sbin/rmmod -s sidewinder
/sbin/rmmod -s ns558
/sbin/rmmod -s emu10k1_gp
/sbin/rmmod -s joydev
/sbin/rmmod -s gameport
/sbin/modprobe -s joydev
/sbin/modprobe -s gameport
/sbin/modprobe -s ns558
/sbin/modprobe -s sidewinder
as of now this does not work (the pads are NOT plugged into the sblive card) and if I do plug them into the SBLive, and use:
/sbin/rmmod sidewinder
/sbin/rmmod ns558
/sbin/rmmod emu10k1_gp
/sbin/rmmod joydev
/sbin/rmmod gameport
/sbin/modprobe joydev
/sbin/modprobe gameport
/sbin/modprobe emu10k1_gp
/sbin/modprobe sidewinder
none of the sidewinder pads show up, but both of these worked just fine in FC4.... does anyone know what are the possible options to pass to emu10k1_gp, gameport and sidewinder to specify addresses and joypads?)
Best Regards
Hybrid Mode
