View Full Version : Error when setting up WAN
24th September 2005, 03:22 PM
I have installed the drivers for my Belkin 54g G notebook card. However, when I finish I get this error: "set mode:8B06"
"SET failed on device eth:01"
The device has been activitated, but I still can't connect to the internet. The network is already setup and working for this computer (running XP).
25th September 2005, 07:46 PM
Does the computer need a localhost file in order for the internet to work, or connect to a network?
25th September 2005, 08:40 PM
I don't know how much help this will be, but I have a Dell Broadcom 1300 (54g) card in my laptop and I got it working great with ndiswrapper. I got it from the livna repositories - just get the right version for your computer (i686 was mine) and the correct kernel version (every time you update the kernel you have to uninstall, the install ndiswrapper again as it's very kernel dependent).
Once installed, try "ndiswrapper -i <inffilename>" then "ndiswrapper -m" then reboot. replace <inffilename> with the inf from your setup cd or whatever - it's the same inf that windows uses when installing the card.
Hope that helps you out.
- Eastside Gallery- Section Of The Berlin Wall
- Concord, MA Travel Photos
vBulletin® v3.8.7, Copyright ©2000-2014, vBulletin Solutions, Inc.