Epson Stylus Photo 750

[savage]

Hi all, I've got an Epson Stylus Photo 750 connected via usb, the device is picked up by the printer config, as /dev/usb/lp0 and identified correctly.

It's setup to use the gimp-print-ijs driver (the recommended), and all seems well until I attempt a test page, it sits for a while, then says aborted, return code 3.

I've tried the other two drivers in the list (stc740ih.upp and stcolor) with no avail.

Does anyone have any suggestions on whats causing this?

Thanks, Savage

[savage]

This is the content of the bottom of the error.log file in the cups folder:
D [30/Jul/2005:13:45:45 +0100] AcceptClient: 11 from localhost:631.
D [30/Jul/2005:13:45:45 +0100] ReadClient: 11 POST /printers/ HTTP/1.1
D [30/Jul/2005:13:45:45 +0100] ProcessIPPRequest: 11 status_code=0
D [30/Jul/2005:13:45:45 +0100] ReadClient: 11 POST /classes/ HTTP/1.1
D [30/Jul/2005:13:45:45 +0100] ProcessIPPRequest: 11 status_code=0
D [30/Jul/2005:13:45:45 +0100] CloseClient: 11
D [30/Jul/2005:13:50:44 +0100] Closing client 10 after 300 seconds of inactivity...
D [30/Jul/2005:13:50:44 +0100] CloseClient: 10
D [30/Jul/2005:13:50:45 +0100] Closing client 9 after 300 seconds of inactivity...
D [30/Jul/2005:13:50:45 +0100] CloseClient: 9