Atheros driver disk for FC3

[rray]

I've been trying to build a driver disk for FC3 so I can perform a network install using an Atheros wireless card.
I write this to a ext2 formatted floppy disk.
I'm using FC3-i386-rescuecd.iso to boot and enter "linux dd" at the prompt.
When prompted I load the driver disk and ALT-F3 to view progress.

probing buses
finished bus probing
modules to insert wlan ath_rate_onoe ath_hal ath_pci
module(s) wlan ath_rate_onoe ath_hal ath_pci not found
load module set done

The driver disk is too large, 1.1MB, to attach.
I'll send it to anyone who wouldn't mind helping debug this.
I'd appreciate it if someone could point out my stupidity.

Thanks
Richard Ray