Input Signal out of range

[adamskim]

I have problem with my monitor (Gateway FDP 1930) It appeared during installation process. Monitor was recognized very well. And when anaconda started the monitor went into standby mode and there was "Input Signal out of range" on it. I tried to install with 'noprobe' and 'resolution' option but it didn't help.
I installed in text mode, but I have the same problem when system is starting.
I must add that when I use other monitor everything work fine.

I'm very disappointed :(

Thanks for help!

[rega451]

Have you tried disabling your power save options in your CMOS setup? If not, try it and see if that fixes it.