TVTime with hauppauge card - no sound

[blueuniverse]

Ok, wasn't sure where to put this so I thought this forum would be best.

My PC setup is

- Fedora Core 3 with KDE desktop environment
- Hauppauge WinTV PCI-Radio Card
- On-board sound, realtek chip. The motherboard is a Gigabye 7VA
- Running TVTime


I can post other areas but I'm pretty sure that is the only relevant area. I have had a look around and on FC2 people advised to run gnome-alsamixer but I get a file not found when running this command on FC3. I have checked all the volume controls but I get nothing.

I am almost certain getting a new sound card would solve this as I have the sound on a line in I think.

I get ABSOLUTELY no sound (not even white noise or anything) when viewing the TV picture (which comes up fine, or rather did but I appear to have lost it now, probably my own fault).


Does anybody have any suggestions to resolving this?

[tiberiu]

Hi!

Maybe yuo'll find it funny but did you check you kmix / Input tab -> all are mute?

A suggestion...

Best regards

[blueuniverse]

kmix / input tab - all were mute but now I've changed them I don't notice anything different. On a slightly positive note I have got the picture working again but still no sound.

[blueuniverse]

Ah, found the problem I think. I typed alsamixer instead of gnome-alsamixer in the terminal and it came up. Line in is set on mute but I am a bit of a newbie to Fedora, and I don't have a clue how to change it.

[blueuniverse]

Ok, I've sorted it now. The switch in Kmix was off for the line input.

[tiberiu]

Perfect!

Now... Don't stay to much in front of your TV, it's not good for your eyes :)

Best regards.