shedyed
7th February 2012, 10:11 AM
I was wondering if it was possible to have xonclock updated (specifically for F14). I have searched on some RPM sites and it seems to have been excluded after F8. It has some nice built-in themes, and I usually run several for different time zones, since I have a dual head monitor.
My other recourse is to attempt to build from source, but I have not set up a developer workstation, only a basic one. Would appreciate some tips on this, as I would like to install only the most minimal setup required to enable roll-your-owns/compiles-from-targz. Thanks!
My other recourse is to attempt to build from source, but I have not set up a developer workstation, only a basic one. Would appreciate some tips on this, as I would like to install only the most minimal setup required to enable roll-your-owns/compiles-from-targz. Thanks!
