seph
2004-08-16, 07:31 AM CDT
ok question for you guys....
I tried to make a cd w/ CD Creator in Gnome. It made tghe ISO and started to spin up the cd-r and thne it spit it back out at me...and gave me the folowing error msgs:
cdrecord: fifo was 0 times empty and 0 times full, min fill was 100%.
cdrecord: fifo had 64 puts and 0 gets.
cdrecord: OPC failed.
cmd finished after 18.244s timeout 60s
Sense flags: Blk 0 (not valid)
Sense Code: 0x03 Qual 0x00 (peripheral device write fault) Fru 0x0
Sense Key: 0x4 Hardware Error, Segment 0
Sense Bytes: 70 00 04 00 00 00 00 0A 00 32 00 10 03 00 00 00
status: 0x2 (CHECK CONDITION)
CDB: 54 01 00 00 00 00 00 00 00 00
cdrecord: Success. send opc: scsi sendcmd: no error
cdrecord: WARNING: This causes a high risk for buffer underruns.
cdrecord: Permission denied. WARNING: Cannot set priority using setpriority().
cdrecord: Operation not permitted. WARNING: Cannot set RR-scheduler
SCSI buffer size: 64512
cdrecord: Warning: using inofficial libscg transport code version (schily - Red Hat-scsi-linux-sg.c-1.80-RH '@(#)scsi-linux-sg.c 1.80 04/03/08 Copyright 1997 J. Schilling').
Linux sg driver version: 3.5.27
Warning: Open by 'devname' is unintentional and not supported.
scsibus: -2 target: -2 lun: -2
devname: '/dev/hdc'
scsidev: '/dev/hdc'
cdrecord: WARNING: This causes a high risk for buffer underruns.
cdrecord: Permission denied. WARNING: Cannot set priority using setpriority().
cdrecord: Operation not permitted. WARNING: Cannot set RR-scheduler
cdrecord: WARNING: This causes a high risk for buffer underruns.
cdrecord: Operation not permitted. WARNING: Cannot do mlockall(2).
cdrecord: Continuing in 5 seconds...
cdrecord: Future versions of cdrecord may have different drive dependent defaults.
cdrecord: Asuming -tao mode.
cdrecord: No write mode specified.
any sugestions.....??
seph
I tried to make a cd w/ CD Creator in Gnome. It made tghe ISO and started to spin up the cd-r and thne it spit it back out at me...and gave me the folowing error msgs:
cdrecord: fifo was 0 times empty and 0 times full, min fill was 100%.
cdrecord: fifo had 64 puts and 0 gets.
cdrecord: OPC failed.
cmd finished after 18.244s timeout 60s
Sense flags: Blk 0 (not valid)
Sense Code: 0x03 Qual 0x00 (peripheral device write fault) Fru 0x0
Sense Key: 0x4 Hardware Error, Segment 0
Sense Bytes: 70 00 04 00 00 00 00 0A 00 32 00 10 03 00 00 00
status: 0x2 (CHECK CONDITION)
CDB: 54 01 00 00 00 00 00 00 00 00
cdrecord: Success. send opc: scsi sendcmd: no error
cdrecord: WARNING: This causes a high risk for buffer underruns.
cdrecord: Permission denied. WARNING: Cannot set priority using setpriority().
cdrecord: Operation not permitted. WARNING: Cannot set RR-scheduler
SCSI buffer size: 64512
cdrecord: Warning: using inofficial libscg transport code version (schily - Red Hat-scsi-linux-sg.c-1.80-RH '@(#)scsi-linux-sg.c 1.80 04/03/08 Copyright 1997 J. Schilling').
Linux sg driver version: 3.5.27
Warning: Open by 'devname' is unintentional and not supported.
scsibus: -2 target: -2 lun: -2
devname: '/dev/hdc'
scsidev: '/dev/hdc'
cdrecord: WARNING: This causes a high risk for buffer underruns.
cdrecord: Permission denied. WARNING: Cannot set priority using setpriority().
cdrecord: Operation not permitted. WARNING: Cannot set RR-scheduler
cdrecord: WARNING: This causes a high risk for buffer underruns.
cdrecord: Operation not permitted. WARNING: Cannot do mlockall(2).
cdrecord: Continuing in 5 seconds...
cdrecord: Future versions of cdrecord may have different drive dependent defaults.
cdrecord: Asuming -tao mode.
cdrecord: No write mode specified.
any sugestions.....??
seph