Kernel 2.6.27-3.fc10x86 FAILURE

[cloneu2]

When I do a kernel update it will install all the files into the boot dir but when it comes time to build initrd-2.6.27-1.fc10.x86_64.img the system just sits there and I have to ctrl-c to quit. It never gets installed. I have used yumex to remove the kernel and tried to install it from the command line and still the same problem...
This one got me.. Any suggestions?
_______________________ERROR Message_________________

error: %post(kernel-2.6.27-3.fc10.x86_64) scriptlet failed, signal 2
__________________________________________________ ___

[cloneu2]

STILL SAME PROBLEM with kernel-2.6.27-13.fc10.x86_64.img. will install the kernel but does not make initrd-2.6.27-13.fc10.x86_64.img.. I have gone to the terminal and put in the command

mkinitrd /boot/initrd-2.6.27-13.fc10.x86_64.img 2.6.27-13.fc10.x86_64

and it just hangs. When I ctrl-c i get back to the command prompt. no file is made, I have removed the kernel and tried a reinstall using yumex and it just hangs at 99% done.....

There has to be an answer out there somewhere..

Thanks

[cloneu2]

SOLVED!

I did a kernel update to the new rc1 from a fresh boot to init 3. All went fine... Installed the dev and headers and then was able to install the nvidia drivers and have a happy machine once again:)