FC6 Monitor out of range!!

[crazyjedi]

I've just installed FC6 but when i boot up all i get is a blank screen and a message telling me analogue 14/15 out of range. I can't see anything let alone log in the monitor is a Xerox XM series 19 inch wide screen. My graphics card was recognised and is a Geforce 7300gt.
Previously i ran into many problems with a standard 15inch monitor whilst running FC5 which i was never able to totally solve.
Please help i had high hopes for FC6 but this is a less than perfect start :mad:

[Seve]

Hello:
Have a look here :http://forums.fedoraforum.org/showthread.php?t=134019&highlight=range
and or here: http://forums.fedoraforum.org/showthread.php?t=135648&highlight=range

Seve

[crazyjedi]

This is a new install on a pc that i recently built so i haven't used linux for a while and am a little rusty to say the least. I'll need walkin thru this.
after rebooting the pc and selecting FC6 from GRUB it boots and then blanks out how do i make any changes to the moitor settings at this point ??

[leigh123linux]

ctrl+alt+F6 to get terminal

login root and type

nano /etc/X11/xorg.conf and comment out (#) the vert and horiz lines and let it auto detect.

save and reboot

[crazyjedi]

Cannot login as root cuz all i'm displayed is a blank screen with the box "analog RGB 15khz/14hz out of range" no amount of key tapping brings up anything visible on the screen' How would i go about changing the display options during boot up cuz as soon as it boots i'm blind.

[leigh123linux]

ok use install disk

type in linux rescue
mount sysimage writeable then you can

nano /etc/X11/xorg.conf and comment out (#) the vert and horiz lines and let it auto detect. and check driver "vesa" may be better

[crazyjedi]

Tried your idea but nothing.
Either it didn't work or i did it wrong. Give me exact instructions on what to type and when and i'll let you know how it goes.
nothing seems to work so far tho.